Fillers

White plaster filler reinforced with cellulose for patching holes and cracks in most interior surfaces.

• Suitable for cement plasters.
• Excellent for concrete brick.
• For cement based surface and asbestos.

Ensure surfaces are clean, dry, free from grease, fungus and other impurities. Moisture content and pH of the surface applied should be below 8% and pH 9.5 respectively, remove old peeling paint works before applying.

Application

• Stir thoroughly before use. Use direct or if thinning is required, use clean water.
• Application can be done by brush or roller by adding 10 to 20% of water and stir well if it is too dry.
• Allow the coat to dry (dry time in normal temperature between 20°C - 30°C).
  Touch dry : 15 min.
  Hard dry : 2 hours
  Full hard dry : 4 hours
  Re-application interval : 2 hours if required.

Cleaning of Equipment
Clean all tools and application equipment with clean water immediately after use. Hardened or cured material can only be removed mechanically.

Technical Information

Adhesion	Adheres firmly to all surfaces which are clean, dry and grease free. Will not crack or fall out when dry.
Colour	White
Coverage	Approximately 4m2/kg.
Drying time	A thin film dries in approximately 15 - 30mins when used for leveling irregular surfaces, drying time may vary depending on thickness.
Thickness	Apply approximately 0.5 - 1.5mm as a plaster coat before painting.
Odour	Odourless when dry.

 

Storage Conditions
Store properly in dry conditions, in undamaged and unopened, original sealed packaging. Keep away from direct sunlight, rain, water and moisture.